48
KX-TG2853BXS/KX-TG2854BXS/KX-TGA280BXS
12.2. The Setting Method of JIG (Base Unit)
12.2.1. Preparation
12.2.1.1. Equipment Required
• Frequency counter: It must be precise enough to measure intervals of 1 Hz (precision; ±4 ppm).
Hewlett Packard, 53131A is recommended.
• Digital multi-meter (DMM): It must be able to measure voltage and current.
• Oscilloscope
12.2.1.2. JIG and PC
• Serial JIG
JIG Cable: PQZZ1CD300E*
• PC which runs in DOS mode
• Batch file CD-ROM for setting: PQZZTG2873BX
12.2.2. PC Setting
12.2.2.1. Connections
Connect the AC adaptor to CN301 (base unit).
Connect the JIG Cable GND (black).
Connect the JIG Cable RX (red) and TX (yellow).
Note:
*: COM port names may vary depending on what your PC calls it.
To Next Page
Loading...
