51
KX-TG2853BXS/KX-TG2854BXS/KX-TGA280BXS
12.3.2.2. Batch file Settings
Note:
• “****” varies depending on the country.
• Refer to Commands (P.51) for frequently used commands.
12.4. Commands
Command name Function Example
getver Check software version Type “getver”, then registered software version is read out.
readid Read ID (RFPI) Type “readid”, then registered ID is read out.
bandgap Check VDD adjustment parameter value Type “bandgap”, then registered bandgap adjust value is read out.
bandgap nn Set VDD voltage adjustment parameter value Type “bandgap nn”, nn is an adjustment setting value of the bandgap voltage.
conttx Set RFC (burst mode) Type “conttx”, then set RF-burst mode.
setfreq Check frequency adjustment parameter value Type “setfreq”, then registered freq adjustment value is read out.
setfreq nn Set frequency adjustment parameter value Type “setfreq nn”, nn is an adjustment setting value of the frequency.
eeprom_hs_init Set default data to the EEPROM (handset) Type “eeprom_hs_init”, then default data is registered.
To Next Page
Loading...
