Programming
21
Programmable settings
You can customize the unit by programming the following features using the handset.
To access the features, there are 2 methods.
■ Scrolling through the display menus
1 {MENU}
2 Press {V} or {^} to select the desired main menu. s {SELECT}
3 Press {V} or {^} to select the desired item from the next sub-menus. s {SELECT}
4 Press {V} or {^} to select the desired setting. s {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {OFF}.
■ Using the direct command code
1 {MENU} s Enter the desired code.
Example: Press {MENU}(1)1.
2 Select the desired setting. s {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {OFF}.
Note:
L In the following table, < > indicates the default settings.
L In the following table, + indicates the reference page number.
L Display menu order and sub-menu may vary depending on your model.
Display the menu tree and direct command code table
Main menu: \ “Caller list”
Main menu: e “Answering device”
*1
Operation Code +
Viewing the caller list. #213 30
Sub-menu 1 Sub-menu 2 Setting Code +
Play new msg.
(msg.: message)
––#323 33
Play all msg. ––#324 34
Erase all msg.
*2
––#325 34
Greeting Record greeting
*2
– #302 33
Check greeting – #303 33
Pre-recorded
*2
(Reset to pre-recorded
greeting)
– #304 33
TG41xxC(e).book Page 21 Wednesday, December 22, 2010 3:59 PM
To Next Page
Loading...
