Programming
25
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
L Set the date and time beforehand (page
14).
1 {MENU}(72)
2 {r}: Select the desired alarm option. s
{SELECT}
3 Enter the desired month and date. s
{OK}
4 Set the desired time.
5 {AM/PM}: Select “AM” or “PM”. s {OK}
6 {r}: Select the desired alarm tone. s
{SELECT}
L We recommend selecting a different
ringer tone from the one used for
outside calls.
7 {SELECT} s {OFF}
L When the alarm is set, E is displayed.
Note:
L To stop the alarm, press {OFF} or place the
handset on the base unit or charger.
L When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Night mode
Night mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set for each handset.
Important:
L Set the date and time beforehand (page
14).
L We recommend turning the base unit ringer
off (page 17) in addition to turning the night
mode on.
(KX-TG4131 series: page 3)
L If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1 {MENU}(238
2 {r}: Select the desired setting. s
{SAVE}
L If you select “Off”, press {OFF} to
exit.
3 Enter the desired hour and minute you
wish to start this feature.
4 {AM/PM}: Select “AM” or “PM”. s {OK}
5 Enter the desired hour and minute you
wish to end this feature.
6 {AM/PM}: Select “AM” or “PM”.
7 {SAVE} s {OFF}
L When the night mode is set, 3 is
displayed.
Changing the start and end time
1 {MENU}(237
2 Continue from step 3, “Turning night
mode on/off”, page 25.
Changing the handset name
Each handset can be given a customized
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 {MENU}(1)4
2 Enter the desired name (max. 10
characters; see the character table, page
19).
L If not required, go to step 3.
3 {SAVE}
Off Turns alarm off. Go to step 7.
Once An alarm sounds once at the
set time.
Daily An alarm sounds daily at the
set time. Go to step 4.
TG41xxC(e).book Page 25 Wednesday, December 22, 2010 3:59 PM
To Next Page
Loading...
