Programmable Settings
For assistance, please call 1-800-211-PANA (7262). 35
Handset ringer tone
You can change the ringer tone heard
when an outside call is received. There are
3 tones and 4 melodies. The default
setting is “Tone 1”.
1 Press {MENU}.
2 Scroll to “Ringer setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Ringer tone” by pressing
{V} or {^}, then press {>}.
4 Press {V} or {^} repeatedly to select
the desired setting.
L You can also select the ringer tone by
pressing {1} to {7}.
L If the ringer volume has been turned
off, the handset will not ring.
5 Press {Save}, then press {OFF}.
Note:
L If you subscribe to a distinctive ring
service (such as IDENTA-RING), select
a tone (Tone 1 to 3). If you select a
melody, you will not be able to
distinguish lines by their ringers.
L If you select one of the melody ringer
patterns, the ringer will continue to
sound for several seconds if:
– the caller hangs up before you answer
the call.
– another person answers the call using
another phone connected on the
same line.
Handset interrupt tone
This tone lets you know when you receive
a call while you are on an intercom call
(page 30).
“2” (default): The tone will sound 2 times.
“On”: The tone will sound for as long as the
line rings.
“Off”: Turns this feature off.
1 Press {MENU}.
2 Scroll to “Ringer setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Interrupt tone” by
pressing {V} or {^}, then press {>}.
4 Press {V} or {^} repeatedly to select
the desired setting.
5 Press {Save}, then press {OFF}.
Ringer setting
Ringer tone
Ringer tone
1=Tone 1
K
Back
dB
Save
L
TG5438_5439.book Page 35 Friday, August 25, 2006 9:35 AM
To Next Page
Loading...
