Answering System Features
For assistance, please call 1-800-211-PANA (7262). 49
*1 If pushed within the first 5 seconds of a
message, the previous message will be
played.
*2 To resume operation, enter a remote
command within 15 seconds, or the
voice guidance will start.
Turning on the answering system
remotely
If the answering system is off, you can turn
it on remotely.
1 Dial your phone number.
2 Let the phone ring 15 times.
L The unit will answer your call with the
greeting message.
L You can hang up, or if you call from a
touch tone phone, you can enter your
remote code and begin remote
operation (page 48).
Skipping the greeting message to leave
a message
You can leave a message just as any
outside caller can. Call your phone
number, then press {*} to skip the
greeting message and record your
message after the beep.
Answering system
settings
Remote code
A remote code must be entered when
operating the answering system remotely.
This code prevents unauthorized parties
from listening to your messages remotely.
Store any 2-digit number (00–99). The
default setting is “11”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Remote code” by pressing
{V} or {^}, then press {>}.
5 Select the desired remote code by
entering a 2-digit number (00–99).
6 Press {Save}, then press {OFF}.
Note:
L To confirm the remote code, repeat
steps 1 to 4. Press {OFF} when finished.
TG5438_5439.book Page 49 Friday, August 25, 2006 9:35 AM
To Next Page
Loading...
