Useful Information
53
Answering system (KX-TG6421)
Problem Cause/solution
The unit does not record new
messages.
L The answering system is turned off. Turn it on
(page 35).
L The message memory is full. Erase
unnecessary messages (page 37).
L The recording time is set to “Greeting
Only”. Change the setting (page 40).
L If your own greeting message is not recorded
properly, callers are unable to leave a
message. Record your own greeting message
again (page 36).
L If you subscribe to a voice mail service,
messages are recorded by your service
provider/telephone company, not your
telephone. Change the unit’s number of rings
setting or contact your service provider/
telephone company (page 39).
My own greeting message
cannot be properly heard.
L Record your own greeting message again
(page 36).
I cannot operate the answering
system.
L Someone is using the unit. Wait for the other
user to finish.
L A caller is leaving a message. Wait for the
caller to finish.
L The handset is too far from the base unit.
Move closer.
I cannot operate the answering
system remotely.
L You are entering the wrong remote access
code. If you have forgotten your remote
access code, enter the remote access code
setting to check your current code (page 38).
L Press each key firmly.
L The answering system is turned off. Turn it on
(page 39).
L You are using a rotary/pulse telephone. Try
again using a touch-tone phone.
While recording a greeting
message or listening to
messages, the unit rings and
the operation stops.
L A call is being received. Answer the call and
try again later.
TG6411-6421FX(e).book Page 53 Friday, February 27, 2009 11:44 AM
To Next Page
Loading...
