Panasonic KX-TG6461E

Phonebook
18
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
1 Find the desired entry (page 17). i 8
2 {V}/{^}: “Edit” i M
3 Edit the name if necessary (16 characters
max.; page 37). i M
4 Edit the phone number if necessary (24 digits
max.). i M 2 times i {ih}
Erasing entries
Erasing an entry
1 Find the desired entry (page 17). i 8
2 {V}/{^}: “Erase” i M
3 {V}/{^}: “Yes” i M i {b}
Erasing all entries
1 n (left soft key) i 8
2 {V}/{^}: “Erase All” i M
3 {V}/{^}: “Yes” i M
4 {V}/{^}: “Yes” i M i {b}
Erasing an entry
1 Find the desired entry (page 17). i 8
2 {V}/{^}: “Erase” i M
3 {V}/{^}: “Yes” i M i {ih}
Erasing all entries
1 n (left soft key) i 8
2 {V}/{^}: “Erase All” i M
3 {V}/{^}: “Yes” i M
4 {V}/{^}: “Yes” i M i {ih}
Chain dial
This feature allows you to dial phone numbers in
the phonebook while you are on a call. This feature
can be used, for example, to dial a calling card
access number or bank account PIN that you have
stored in the phonebook, without having to dial
manually.
1 Proceed with the operation for your unit.
Base unit:
During an outside call, press n.
Handset:
During an outside call, press 8. i M
2 {V}/{^}: Select the desired entry.
3 Press M to dial the number.
Note:
L When storing a calling card access number and
your PIN in the phonebook as one phonebook
entry, press {R } on the base unit or l on the
handset to add pauses after the number and
PIN as necessary (page 14).
Speed dial
You can assign 1 phone number from the
phonebook to each of the 5 speed dial buttons.
Assigning a phonebook entry to a speed dial
button
1 Find the desired entry (page 17).
2 Press the speed dial button you want to
assign to. i M
L If “Overwrite” is displayed, the button
you selected has a phone number already
assigned to it.
To overwrite with the currently selected
phone number, go to step 3.
To select another button, press U, then
repeat this step.
3 M i {b}
Note:
L In step 2, you can also press 8. i
{V}/{^}: “Speed Dial” i M i
{V}/{^}: Select the desired speed dial button.
i M
L If a speed dial button has already been
assigned, “Q” is displayed next to the button in
step 2.
Y Handset
= Base unit
Y Handset
= Base unit / Y Handset
= Base unit
TG6461E(e).book Page 18 Monday, March 16, 2009 8:50 AM