Programming
22
Programming using the direct commands
1
{MENU} i {#}
2 Enter the desired code.
3 Select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {OFF}.
Note:
L In the following table, < > indicates the default settings.
Feature Code Setting System
*1
Page
Caller list {2}{1}{3} ––29
V.M. access
(V.M.: Voice mail)
{3}{3}{0} ––38
Intercom {2}{7}{4} ––40
Date and time {1}{0}{1} – r 12
Alarm {7}{2}{0}{1}: Once
{2}: Daily
{0}: <Off>
–25
Time
adjustment
*2
{2}{2}{6}{1}: Caller ID auto
{0}: <Manual>
r –
Ringer volume
*3
(Handset)
{1}{6}{0}{1}–{6}: Level 1–6 <6>
{0}: Off
––
Ringer tone
(Handset)
*4,
*5
{1}{6}{1}{1}–{5}: Tone 1–5
<Tone 1>
{6}–{0}: Melody 1–5
––
Night mode
(On/Off)
{2}{3}{8}{1}: On
{0}: <Off>
–25
Night mode
(Start/End)
{2}{3}{7} <23:00/06:00>–25
Handset name {1}{0}{4} ––26
Call block {2}{1}{7} – r 26
Block w/o num
(Block calls without
phone number)
{2}{4}{0}{1}: On
{0}: <Off>
r 26
Store VM
access#
(VM: Voice mail)
{3}{3}{1} – r 38
Message alert {3}{4}{0}{1}: <On>
{0}: Off
–37
LCD Contrast
(Display contrast)
{1}{4}{5}{1}–{6}: Level 1–6 <3> – –
TG654xBX(e).book Page 22 Tuesday, June 28, 2011 10:16 AM
To Next Page
Loading...
