Panasonic KX-TG6841B

27
KX-TG6841B/KX-TG6842B/KX-TG6843B/KX-TG6844B/KX-TG6845B/KX-TG6873B/KX-TGA680B
8 Test Mode
8.1. Engineering Mode
8.1.1. Base Unit
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
1). Press {MENU}.
2). Select "Initial setting" using or
then press
{SELECT} or {>}.
H/S key operation
H/S LCD
{^} {V}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
*
5). Enter "
٨ ", " ٨ ", " ٨ ", " ٨ " (Address). (*1)
7). Press
{OK} , a long confirmation beep
will be heard.
8).
Press to return to standby mode.
After that, turn the base unit power off and then power on.
Note: * To enter "Set dial mode", press {SELECT} or {>} at " Set tel line".
It is necessary to turn on the power of base unit.
6). Enter " 㧖 ", " 㧖 " (New Data). (*1)
4). Select "Write EEP" using or
then press
{SELECT} or {>}.
{^} {V}
Default Data
New Data
Phonebook
^
V
^
V
Initial setting
^
V
Set tel line
^
V
Set dial mode
Select "Set tel line" using or
then press
{SELECT} or {>}.
{^} {V}
Service Mode
Read EEP
Write EEP
Set Addr.:
_ _ _ _ _ _
Set Addr.:
Set Addr.:
{OFF}
Soft keys
Navigator key/
? (Volume) key
{OFF}
{FLASH}
{CALL WAIT}
Dial keypad
INT
SELECT
INT
SELECT
BACK
SELECT
BACK
SELECT
BACK
SELECT
CLEAR
OK
CLEAR
OK
BACK
z
z
z
C