Preparation
11
Panasonic Ni-MH battery
performance (supplied batteries)
Note:
L It is normal for batteries not to reach
full capacity at the initial charge.
Maximum battery performance is
reached after a few complete cycles of
charge/discharge (use).
L Actual battery performance depends
on a combination of how often the
handset is in use and how often it is
not in use (standby).
L Even after the handset is fully
charged, the handset can be left on
the base unit or charger without any ill
effect on the batteries.
L The battery level may not be
displayed correctly after you replace
the batteries. In this case, place the
handset on the base unit or charger
and let it charge for at least 7 hours.
Turning the power
on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Setting up the unit
before use
Region settings
You can set the unit to use settings that
match your country (page 20). The
display language and other settings will
change accordingly.
Note:
L The display language only changes
(to the selected country’s default
setting) for the handset used to select
the region setting. You must change
the display language for all other
handsets separately.
Display language
16 display languages are available.
1 {ih} i {j/OK}
2 Press {^} or {V} to select “Handset
Setup”. i {>}
3 Press {^} or {V} to select “Display
Setup”. i {>}
4 Press {^} or {V} to select “Select
Language”. i {>}
5 Press {^} or {V} to select the
desired language. i {>} i
{ih}
Operation Operating
time
In continuous use 17 hours max.
In continuous
standby mode
180 hours
max.
You can select
To Next Page
Loading...
