Panasonic KX-TG7220FX - Answering System Settings

Answering System Features
30
system remotely. This code prevents
unauthorised parties from listening to
your messages remotely.
1 {j/OK}
2 {^}/{V}: “Answer System” i
{>}
3 {^}/{V}: “Settings” i {>}
4 {^}/{V}: “Remote Code” i {> }
5 To turn on remote operation, enter a
3-digit remote access code.
L To turn off remote operation,
press {*}.
6 {j/OK} i {ih}
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2 After the greeting message starts,
enter your remote access code.
L The unit will announce the
number of new messages.
3 Enter remote commands.
Note:
L You can hang up at any time.
Remote commands
Turning on the answering
system remotely
If the answering system is off, you can
turn it on remotely.
1 Dial your phone number from a
touch-tone phone.
2 Let the phone ring 9 times.
L A long beep will be heard.
3 Enter your remote access code
within 10 seconds after the long
beep.
L The greeting message is played
back.
L You can hang up, or enter your
remote access code again and
begin remote operation.
Answering system
settings
If the base unit is reset to its default
settings (page 20), the following
answering system-related settings will
be reset.
Key Operation
{1} Repeat message (during
playback)
*1
{2} Skip message (during
playback)
{4} Play new messages
{5} Play all messages
{6} Play greeting message
{7} Record greeting
message
{9} Stop (recording,
playback)
{0} Turn answering system
off
{*}{4} Erase currently playing
message
{*}{5} Erase all messages
{*}{6} Erase greeting message
(during greeting message
playback)
{*}{#} End remote operation (or
hang up)
*1 If pressed within the first 5
seconds of a message, the
previous message will be played.
Key Operation
TG7200-7220FX(e-e).book Page 30 Friday, June 29, 2007 10:24 AM