Answering System Features
29
2 {^}/{V}: “Answer System” i
{>}
3 {^}/{V}: “Erase Message” i
{>}
4 {^}/{V}: “Erase All” i {>}
5 {^}/{V}: “Yes” i {>} i {ih}
Calling back (Caller ID
subscribers only)
If caller information was received for the
call, you can call the caller back while
listening to a message.
1 Press {j/OK} during playback.
2 {^}/{V}: “Call Back” i {>}
Editing the number before calling
back
1 Press {j /OK} during playback.
2 {^}/{V}: “Edit and Call” i
{>}
3 Edit the number. i {C}
Direct command
operation using the
handset
You can operate the answering system
by pressing dial keys, rather than
navigating through the menus.
To use the following commands:
{j/OK} i {^}/{V}: “Answer
System” i {>}
Remote operation
Using a touch-tone phone, you can call
your phone number from outside and
access the unit to listen to messages or
change answering system settings.
Important:
L In order to operate the answering
system remotely, you must first turn
on remote operation by setting a
remote access code. This code must
be entered each time you operate the
answering system remotely.
Turning remote operation on
A 3-digit remote access code must be
entered when operating the answering
Key Operation
{1} Repeat message (during
playback)
*1
{2} Skip message (during
playback)
{3} Enter the “Settings”
menu
{4} Play new messages
{5} Play all messages
{6} Play greeting message
{7}{6} Record greeting
message
{8} Turn answering system
on
{9} Stop (recording,
playback)
{0} Turn answering system
off
{*}{4} Erase currently playing
message
{*}{5} Erase all messages
{*}{6} Erase greeting message
*1 If pressed within the first 5
seconds of a message, the
previous message will be played.
Key Operation
TG7200-7220FX(e-e).book Page 29 Friday, June 29, 2007 10:24 AM
To Next Page
Loading...
