Panasonic KX-TG7220FX - Sending a Message

SMS (Short Message Service)
24
Sending a message
Writing and sending a new
message
1
{j/OK}
2 {^}/{V}: “SMS” i {>}
3 {^}/{V}: “Create” i {>}
4 Enter the message (page 36). i
{j/OK}
5 Enter the destination phone number
(20 digits max.). i {j/OK}
■ Using the handset phonebook:
{k} i {^}/{V}: Select the
handset phonebook entry. i
{j/OK} 2 times
■ Using the caller list:
{^}/{V}: Select the party. i
{j/OK} 2 times
■ Using the redial list:
Press {R} repeatedly to select
the phone number. i {j /OK}
2 times
6 To save the message, select “Yes”.
i {>}
7 To send the message, press {>}.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of
up to 612 characters, however, the
maximum number of characters you
can send or receive may be limited by
your SMS service provider/telephone
company. Consult your SMS service
provider/telephone company for
details.
L If your message contains over 160
characters, the message is a long
message and “@@Long Message@@”
is displayed. Your service
provider/telephone company may
treat long messages differently from
other messages. Consult your service
provider/telephone company for
details.
L If your phone is connected to a PBX,
store the PBX line access number
(page 26).
Sending a saved message
1
{j/OK}
2 {^}/{V}: “SMS” i {>}
3 {^}/{V}: “Send List” i {>}
4 To read a saved message, press {^}
or {V} to select the message. i
{j/OK}
5 To send the message, press
{j/OK}. i {^}/{V}: “Send” i
{>}
6 Press and hold {C/T} to erase all
numbers.
7 Continue from step 5, “Writing and
sending a new message”, page 24.
Editing and sending a saved
message
1
{j/OK}
2 {^}/{V}: “SMS” i {>}
3 {^}/{V}: “Send List” i {>}
4 {^}/{V}: Select the message. i
{j/OK}
5 {j/OK} i {^}/{V}: “Edit
Message” i { >}
6 Continue from step 4, “Writing and
sending a new message”, page 24.
Erasing saved messages
1
{j/OK}
2 {^}/{V}: “SMS” i {>}
3 {^}/{V}: “Send List” i {>}
TG7200-7220FX(e-e).book Page 24 Friday, June 29, 2007 10:24 AM