2.5 System Parameters
114 Programming Manual
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Reconnect Sequence on Refuse Call
Specifies the sequence for retrieving a call placed on hold after the extension (in Call Screening
mode) has refused to accept it.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Light-On Sequence for Message Waiting Lamp
Specifies the sequence for turning on the Message Waiting Lamp at an extension.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Feature Manual References
2.2.32 Message Waiting Notification—Lamp
Light-Off Sequence for Message Waiting Lamp
Specifies the sequence for turning off the Message Waiting Lamp at an extension.
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
To Next Page
Loading...
