1.2 Installing and Starting KX-TVM/NCV Maintenance Console
Programming Manual 9
1.2 Installing and Starting KX-TVM/NCV
Maintenance Console
1.2.1 Installing KX-TVM/NCV Maintenance Console
System programming, diagnosis, and data upload/download can be performed with a PC using the
KX-TVM/NCV Maintenance Console software.
This section briefly describes how to install and start KX-TVM/NCV Maintenance Console on a PC
that is connected to the VPS via USB.
System Requirements
Required Operating System
• Microsoft Windows 98 SE, Windows Me, Windows 2000, or Windows XP
Minimum Hardware Requirements
• CPU: 133 MHz Intel Pentium microprocessor
• HDD: 300 MB of available hard disk space
• RAM: 64 MB of available RAM (128 MB recommended)
Software Installation
Note
• To install or uninstall the software on a PC running Windows 2000 Professional or Windows
XP Professional, you must be logged in as a user which is in either the "Administrators" or
"Power Users" group.
• When the VPS is first connected to the PC via USB, a wizard should appear and ask you to
select the appropriate USB driver. Browse for and select the KX-TVM USB driver, which is
copied to the local drive during installation.
Updating other Panasonic Drivers
CAUTION
Installing the USB driver may prevent the USB driver for KX-TDA series or PC Console/Phone
Software from functioning correctly. In this case, update the USB drivers as necessary from the
following folders on the included CD-ROM:
KX-TDA Series: CD-ROM Drive:\TDA_USB Driver\TDA_USB Driver
PC Console/Phone Software: CD-ROM Drive:\TDA_USB Driver\T7601_USB Driver
Note
• Before installing or uninstalling the driver, be sure to close any open applications.
1. Copy the KX-TVM/NCV Maintenance Console setup file to a local drive on
the PC. (Its icon is shown here, on the left.)
2. Double-click the setup file to run the installer.
3. Follow the on-screen instructions provided by the installation wizard.
4. Click Finish.
5. Click OK.
®®
®®
To Next Page
Loading...
