1.2 Installing and Starting KX-TVM/NCV Maintenance Console
Programming Manual 13
Note
• If starting KX-TVM/NCV Maintenance Console for the first time, use the Quick Setup utility
to set the administrator's password and other basic parameters (see 1.8.1 Utility—Quick
Setup).
• Software features, design, and system requirements are subject to change.
Program Mode
When KX-TVM/NCV Maintenance Console is started, you can choose to program the VPS in either
Batch mode or Interactive mode.
a) Batch mode
Batch mode allows you to create new system data files and make modifications to system data
5. Click Connect → USB from the menu bar, or click
Connect on the shortcut bar, select USB in the
Connection Mode dialogue box and click Next.
Note
• To connect to the VPS via USB, the KX-
TVM USB driver must be installed on the
PC, as explained above in "Installing KX-
TVM/NCV Maintenance Console".
6. Select the VPS as the desired USB device, enter the
administrator password (default: 1234), then click
Next.
7. Click Finish when the message Connected! is
displayed.
8. You may now begin programming the VPS. To
choose the area you would like to begin
programming, click the desired icon in the Shortcuts
menu.
To Next Page
Loading...
