Panasonic KX-TVM50 - Page 126

2.5 System Parameters
126 Programming Manual
Note
• This setting applies only when the subscriber has enabled "Intercom Paging" in Incomplete
Call Handling Status.
Value Range
1–10 times
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Caller Recorded Name Announcement Mode
Determines whether or not the VPS announces the caller's name during paging. (In order for the
name to be announced, it must be recorded beforehand.)
Value Range
Disable, Enable
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Paging Code
Specifies the intercom paging code. The settings made here must match the settings of the PBX.
Note
• Each subscriber's Intercom Paging Group Number is determined based on his or her COS.
Value Range
Max. 16 digits consisting of 0–9, , # for all/each group
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Fax Management
You can program the VPS to automatically detect incoming fax calls and forward those calls to a fax
extension. You can specify a maximum of 2 fax extensions as the destination for faxes; if the main fax
extension is not available to receive a fax, the VPS will forward the fax call to the alternate fax
extension.
Automatic Transfer of Incoming Fax Call
Enables or disables the detection of incoming fax calls.
Note
• The VPS can detect incoming fax signals during the first 30 seconds after it answers
incoming calls.