2.5 System Parameters
Programming Manual 133
Value Range
Max. 16 digits consisting of 0–9, , # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
0–9, , #: Dial Codes
Use Caller-ID Modify Table No.
Specifies which Caller ID Modify Table is used when the VPS converts the Caller ID Number sent
from the PBX to the VPS.
Value Range
1–4
Number of Digits in Telephone Number
Specifies the number of digits for Local Area Telephone Numbers. According to this parameter, a call
number sent from the VPS is determined whether the local call or long distance call.
Value Range
1–20
Caller-ID Modify Table No.1–No.4
A maximum of 4 Caller ID Modify tables can be assigned.
Local Area/International Call Code
Specifies the parameters for each Local Area/International Call Code.
Follow the steps below to edit Local Area/International Call Code:
1. Click Click to edit….
2. Select the desired Local Area/International Call Code No. (1–10).
3. Edit each parameter in the Local Area/International Call Code dialogue box.
4. Click OK.
Local Area Code/International Code
Specifies the local area/international codes that are used when the VPS converts the Caller ID
Number sent from the PBX to the VPS.
Value Range
Max. 6 digits consisting of 0–9
To Next Page
Loading...
