Panasonic KX-TVM50 - Page 141

2.6 Hardware (H/W) Settings
Programming Manual 141
Duration
Specifies the duration (length) of the beep tone.
Value Range
200 ms–2800 ms, units 200 ms
Interval
Specifies the length of time between beep tones heard during 2–way recording.
Value Range
0 s–60 s
DTMF Cut Length
Specifies the length of time for DTMF to be deleted when it is detected while recording.
Value Range
0 ms–500 ms
Minimum Message Length
Specifies the minimum message recording length. Messages shorter than the specified minimum
recording length are discarded from the mailbox.
Value Range
0 s–9 s
Call Progress Tone Detection for Inband Mode
This setting determines whether the VPS detects Call Progress Tones during Inband Integration. If
set to "Enable", Call Progress Tones are detected in addition to DTMF signals.
Value Range
Disable, Enable
Port Parameters
Port parameters determine the hardware settings for each VPS port. Parameter can be edited for
each port individually or for multiple port simultaneously.
Follow the steps below to edit multiple ports simultaneously:
1 Click Click to Edit….
2 Check desired ports in the left table in the Edit Multiple Ports dialogue box.
(Click Select All or Clear All as needed, then select/deselect the desired ports.)
3 Edit parameters in the right table in the Edit Multiple Ports dialogue box.
4 Click OK.