2.3 Port/Trunk Service
Programming Manual 73
Time Frame
Specifies the start and end times for each time mode for each day of the week. Each day of the week
can have 1 lunch mode, up to 2 night modes (1 at the beginning and end of the day) and up to 3 break
modes. Lunch and break modes cannot be inserted into a night mode.
Follow the steps below to edit Time Frame:
1. Click Click to Edit….
2. Select a time mode, then enter the start and end times in the "Start At:" and "End At:" fields or
drag the edges of the time mode to mark the start and end times.
To copy the time mode schedule of one day to another day
1. Select a time mode in the desired "copy from" day, and click Copy.
2. Select a time mode in the desired "copy to" day, then click Paste.
To insert a break or lunch mode
1. Right-click the desired time mode.
2. Select "Insert Break" or "Insert Lunch".
3. Click OK.
Note
• This setting is only available when "Automatic" is selected in "Service Mode".
Value Range
00:00–23:59
Feature Manual References
2.2.45 Time Service
Caller ID/DID Call Routing
Enables or disables the Caller ID/DID Call Routing feature.
Value Range
Disable, Enable
Feature Manual References
2.2.8 Caller ID Call Routing (APT/DPT Integration Only)
2.2.19 DID Call Routing (DPT Integration Only)
To Next Page
Loading...
