Panasonic KX-UT136

1.1.6.3 Before Accessing the Web User Interface
Recommended Environment
This unit supports the following specifications:
HTTP Version HTTP/1.0 (RFC 1945), HTTP/1.1 (RFC 2616)
Authentication Method Digest (or Basic)
The Web user interface will operate correctly in the following environments:
Operating System Microsoft
®
Windows
®
XP or Windows 7 operating system
Web Browser Windows Internet Explorer
®
7 or Windows Internet Explorer 8 web
browser
Language (recommended) English
Opening/Closing the Web Port
To access the Web user interface, you must open the unit’s Web port beforehand. For details, refer to the
Operating Instructions on the Panasonic Web site (® see Introduction).
For details about additional features available with direct commands, see Section 3 Phone User Interface
Programming.
Configuring Settings from the Unit
To open the unit’s Web port
1. Press
Setting
or
Setup
.
2. Press [#][5][3][4].
3. Press [ ] or [ ] to select "On" for "Embedded web", and then press [ENTER].
To close the unit’s Web port
1. Press
Setting
or
Setup
.
2. Press [#][5][3][4].
3. Press [ ] or [ ] to select "Off" for "Embedded web", and then press [ENTER].
Configuring Settings from the Web User Interface
To close the unit’s Web port
1. In the Web user interface, click [Web Port Close].
2. Click OK.
Note
• The Web port of the unit will be closed automatically in the following conditions:
– The port close timer configured through the Web user interface expires (® see [Port Close
Timer] in 4.4.4.1 Web Server Settings).
– 3 consecutive unsuccessful login attempts occur.
• The Web
port can be set to stay open continuously, through Configuration file programming (® see
"HTTPD_PORTOPEN_AUTO" in 5.4.5 HTTP Settings). However, please recognize the possibility of
unauthorized access to the unit by doing so.
22 Administrator Guide Document Version 2013-03
1.1.6 Web User Interface Programming