Panasonic LP-V15U - Page 76

76
Category Name Code Function Page
Layout /
Position adjustment
General condition ALC Sets the conditions related to whole le. P.120
Character condition (Shorted
form)
SPC Sets the condition for marking character string per
line.
(X/Y coordinates and laser power correction ratio
only)
P.121
Character conditions STC Sets the condition for marking character string per
line.
P.122
External offset condition OFC Sets input conditions of “External Offset Function” to
switch coordinates using I/O input.
P.125
External offset coordinates OFS Sets offset coordinates used for “External Offset
Function” to switch coordinates using I/O input.
P.125
Step & repeat condition SRC Sets the condition of “Step & Repeat” to mark the
same marking contents on multiple locations in one
le.
P.126
Step & repeat ne-adjustment SRA Sets the ne adjustment of “Step & Repeat” to mark
the same marking contents on multiple locations in
one le.
P.127
Laser condition
Laser power LPW Sets the laser power. P.129
Scan speed SSP Sets the scan speed of the laser. P.129
Laser pulse cycle
[LP-V series only]
MPL Sets the laser pulse cycle of LP-V series. P.130
CW laser pulse cycle/duty
[LP-W series only]
CWL Sets the laser pulse cycle and duty of LP-W series. P.130
CO
2
laser frequency
[LP-400 series only]
MPL Sets the laser frequency of LP-400 series. P.131
Line width/marking pitch WDC Sets the width necessary to avoid crossing at marking
intersection and marking pitch of the bold characters
and bar code.
P.131
Marking quality adjustment WTC Sets laser start point, end point, edge and curve
adjustments, etc.
P.132
ME-LP400V-EX-6