Preparation
0:
Close the card/battery door.
e:
Slide the release lever in the direction
of
the arrow.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
o
caNote
• Remove the battery after use. Store the removed battery
in
the battery carrying case
(supplied).
• Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the
settings on the camera may not be stored properly.
• The supplied battery is designed only for the camera. Do not use it with any other equipment.
• Before removing the card
or
battery, turn the camera off, and wait until the status indicator has
gone off completely. (Otherwise, this unit may no longer operate normally and the card itself
may be damaged
or
the recorded pictures may be lost.)
About the Built-in mary/the Card
The
following
operations
can
be
performed
using
this unit.
• When a card has
not
been inserted: Pictures can be recorded in
the built-in memory and played back.
• When a card has been inserted: Pictures can be recorded on the
card and played back.
• When using the built-in memory
@]~~
(access
indication*)
• When using the card
~
(access
indication*)
* The access indication lights red when pictures are being recorded
on the built-in memory (or the card).
• Memory size: Approx. 50 MB
• Recordable motion pictures: aVGA (320X240 pixels) only
• The built-in memory can be used as a temporary storage device when the card being used
becomes full.
•
You
can copy the recorded pictures to a card. (P82)
• The access time for the built-in memory may
be
longer than the access time for a card.
The
following types
of
cards
can
be
used
with this unit.
(These
cards
are
indicated
as
card
in
the
text.)
VQT1M97 15