Others
• The following pictures cannot be copied.
- When a picture with the same name as the picture to be copied exists
in
the copy
destination. (Only when copying from a card to the built-in memory.)
- Files not based on the DCF standard.
• Moreover, pictures recorded or edited by other equipment may not be copied.
• This message will be displayed when you formatted the built-in memory on a
PC.
-?
Format
the
built-in
memory
on
the
camera
again.
(P25)
The
data
on
the
built-in
memory
will
be
deleted.
• This card has a format which is not recognized by the camera.
-?
Format the card again with the camera after saving necessary data
on
a PC etc. (P25)
• This message appears when the camera is not operating properly.
-?
Turn
the
camera
off
and
on.
If
the
message
persists,
contact
the
dealer
or
your
nearest
Service
Center.
-?
Use a card compatible with this unit. (P15)
•
You
can only use an SOHC Memory Card if using cards with 4
GS
or more capacity.
• An error has occurred accessing the card.
-?
Insert the card again.
• An error has occurred reading the data.
-?
Insert the card again.
• An error has occurred writing the data.
-?
Turn the camera off and remove the card. Insert the card again and turn the camera on.
Make sure the camera is turned off before removing or inserting the card to avoid damage.
• When you set the picture quality to
[3°tr~A]
or
[301f&~9],
we recommend using a high-speed card
with
"1
OMS/s" or greater displayed on the package.
• Depending on the type of
SO
Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
• A folder cannot be created because there are no remaining folder numbers that can be used.
(P84)
-?
Format the card after saving necessary data
on
a
PC
etc. (P25) If you execute
[NO.
RESET]
in
the [SETUP] menu after formatting, the folder number is reset to 100. (P23)
VQT1M97
95
To Next Page
Loading...
Need help?
General
Weight and Dimensions
