- 109 -
Recording
Applicable modes:
Contrast and exposure will be adjusted automatically when there is a big difference in
brightness between the background and subject, to bring the image close to real life.
Settings: [ON]/[OFF]
•
[ ] in the screen turns to yellow when [i.Exposure] is in effect.
• Even when the [Sensitivity] is set to [100], [Sensitivity] may be set higher than [100] if the picture is
taken with [i.Exposure] set to valid.
• Compensation effect may not be achieved depending on the conditions.
Applicable modes:
You can take bright pictures in dark places by setting [Min. Shtr Speed] slower. Also, you can
set it faster to reduce the blur of the subject.
Settings: [AUTO], [1/125], [1/60], [1/30], [1/15], [1/8], [1/4], [1/2], [1]
•
This should usually be set to [AUTO] to take pictures. (When you select a minimum shutter speed
other than [AUTO], [ ] appears on the screen.)
• Depending on the [Sensitivity] setting, the shutter speed may be limited to the fast ones.
• When [AUTO] is selected, shutter speed may be set up to 1 second when there is not much jitter to
adjust with the [Stabilizer], or when [Stabilizer] is set to [OFF].
• Setting [Min. Shtr Speed] to slower speed might increase the chance of jitter, so we recommend
using a tripod and the self-timer for taking pictures.
• Setting [Min. Shtr Speed] to faster speed might make the picture darker, so we recommend
recording the picture in well-lit area. If correct exposure cannot be achieved, [ ] will flash in red
when the shutter button is pressed halfway.
[i.Exposure]
[Min. Shtr Speed]
Minimum shutter speed setting [1/125] [1]
Brightness Darker Brighter
Jitter Less More
To Next Page
Loading...
Need help?
General
