- 61 -
Basic
• Press [MENU/SET] on the version display screen to display information about the software on the
unit.
• Use a battery with sufficient battery power or the AC adaptor (optional) when formatting. Do not turn
the camera off during formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove the
card.
• If the card has been formatted on a PC or other equipment, format it on the camera again.
• It may take longer to format the built-in memory than the card.
• If the built-in memory or the card cannot be formatted, consult Panasonic.
• If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
• The Stabilizer function is switched between [On] and [Off] every time [MENU/SET] is pressed.
• [Stabilizer Demo.] is an approximation.
[Version Disp.] It is possible to check which version of firmware is on the camera.
[Format]
The built-in memory or card is formatted. Formatting irretrievably
deletes all the data so check the data carefully before formatting.
~ [Language] Set the language displayed on the screen.
[Stabilizer Demo.]
Displays the amount of jitter the camera has detected.
A Amount of jitter
B Amount of jitter after correction
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649)
For USA and Puerto Rico assistance, please call:
1-800-211-PANA(7262) or, contact us via the web at:
http://www.panasonic.com/contactinfo
To Next Page
Loading...
Need help?
General
