136
The Flash preset again adds a more yellow hint to counteract any
“blueness” that may occur using flash as an illuminating source.
The Incandescent preset corrects the strong re-yellow cast that is often
predominant in scenes illuminated solely by tungsten lamps.
As there is a marked difference between tungsten halogen and plain
tungsten filament lamps the color correction may not be ideal.
Setting Manual White Balance
Manual white balance set procedure allows the camera to set the correct
white operating point given a white (or neutral grey) target as the
reference.
The Manual white balance
pre-sets; White Set 1 and
White Set 2 give two
independent controls with
which to register two
lighting conditions.
Cursor to the right (►) to
present the target area.
Ensure the target area is
completely covered by the
white, or neutral grey card,
and then press the “SET”
button.
The camera will make an
exposure and set the
white point for you.
If you require to “fine tune”
the operating point set by
the camera you can use
the WB Adjust screen
accessed by using the
right navigation key ►from
the White Set Screen.
To Next Page
Loading...
