5. Focus and Brightness (Exposure) Settings
166
• You can also enlarge the area by rotating the focus ring, moving the focus lever, or
pinching out (P59) the screen or touching the screen twice.
• You can also adjust the focus position by dragging (P59) the screen.
• Pressing [DISP.] resets the focus position back to the centre.
4
Adjust the focus.
A Indicator for ¶ (infinity)
B MF Assist (enlarged screen)
C Peaking
D MF Guide
• The in-focus portions will be highlighted. (Peaking)
• You can check whether the point of focus is to the near
side or to the far side. (MF Guide)
You can perform the following operations:
¢
When using an interchangeable lens with no focus ring, you can perform these operations
after pressing
4
to display the screen that lets you set the area to be enlarged.
• When the picture is displayed in windowed mode, you can enlarge/reduce the picture by
approximately 3 to 6
k; when the picture is displayed in full screen, you can enlarge/
reduce the picture by approximately 3 to 10
k.
• If you use the HDMI output during recording, the screen cannot be enlarged in
windowed mode.
Button operation Touch operation Description of operation
3/4/2/1
¢
Dragging Moves the enlarged area
Pinching out/in Enlarges/reduces the screen in small steps.
s Enlarges/reduces the screen in large steps.
s
Switches the enlarged display (windowed/full
screen)
[DISP.]
¢
[Reset]
¢
Resets the area to be enlarged back to the
centre.
Changing the display of the MF Assist
> [Custom] > [MF Assist Display]
[FULL]: Enlarges the display in full screen.
[PIP]: Enlarges the display in a window on the screen.
•
The display of the assist screen can also be switched by touching [ ] on the focus
adjustment screen.
AF
+
MENU
To Next Page
Loading...
Need help?
General
