173
5. Focus and Brightness (Exposure) Settings
Compensating the Exposure
Applicable modes:
Use this function when you cannot achieve appropriate exposure due to the difference in
brightness between the subject and the background.
•
You can switch the functions between the rear dial and the front dial by pressing [DISP.].
• The Exposure Compensation value can be set within a range of j5 EV to i5EV.
When recording motion pictures, the Exposure Compensation value can be set within a
range of j3 EV to i3EV.
When recording 4K photos, the Exposure Compensation value can be set within a
range of j3EV to i3EV.
• Select [0] to return to the original exposure.
3
Rotate the front dial to adjust the flash output.
• This operation is possible only when [Firing Mode] (P233) in [Flash] is set to [TTL].
• Flash output can also be adjusted using [Flash Adjust.] in [Flash] in the [Rec] Menu.
(P237)
The [ ]/[Fn1] button can be used in two ways, as [ ] (exposure compensation) or
[Fn1] (function 1). At the time of purchase, the button is set to [ ].
•
For details on the function buttons, refer to P70.
1
Press [ ].
2
Rotate the rear dial to compensate the
exposure.
A Exposure Compensation value
B Flash Adjust
Underexposed Properly exposed Overexposed
Compensate the exposure
towards positive.
Compensate the exposure
towards negative.
+1+1 +2+2 +3+3 +4+4 +5+5
-
5
-
5
-
4
-
4
-
3
-
3
-
2
-
2
-
1
-
100
000
+5+5+5
+1+1
0
To Next Page
Loading...
Need help?
General
