11. Using the Wi-Fi function
308
Displaying pictures on a TV
1 Select the menu. (P63)
2 Select [Via Network] or [Direct], and connect. (P328)
3 Select a device you want to connect.
•
When the connection is established, the screen is displayed.
4 Take or play back pictures on this unit.
•
To terminate the connection, follow the steps below:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes]
(You can also terminate the connection by pressing [Wi-Fi]. (P292))
• If you display pictures using the Wi-Fi function, they cannot be output in 4K resolution. To
output them in 4K resolution, connect the camera and the TV with an HDMI micro cable. (P341)
• When a TV is connected to this unit, the TV screen may temporarily return to the status before
the connection. Pictures are displayed again when you take or play back pictures.
• [Effect] and [Sound] of the Slide Show are disabled.
Not available in these cases:
•
Motion pictures and 4K burst files cannot be played back.
• During the multi/calendar playback, pictures displayed on the screen of this unit are not
displayed on TV.
You can display pictures on a TV that supports the
Digital Media Renderer (DMR) function of the DLNA
standard.
Preparations
Set the TV to DLNA waiting mode.
•
Read the operating instructions for your TV.
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Playback on TV]
MENU
To Next Page
Loading...
Need help?
General
