207
6. Shutter and Drive Settings
3 Press 3
/
4 to select the recording method, and then
press [MENU/SET].
4 Press the shutter button halfway.
•
The recording screen will be displayed. You can also
perform the same operation by pressing and holding
[ ] until the recording screen is displayed.
5 Press the shutter button fully.
•
Up to 9999 frames can be recorded.
6 Move the subject to decide on the composition.
•
Repeat recording in the same way.
• If this unit is turned off while recording, a message for
resuming the recording is displayed when the camera is
turned on. Selecting [Yes] allows you to continue the
recording from the interruption point.
7 Touch [ ] to end the recording.
•
You can also end the recording by following the steps
below:
> [Rec]>[Time Lapse/Animation]
• When [Auto Shooting] is set to [OFF], a confirmation
screen will be displayed.
Select [Yes] to end the recording.
8 (When [Auto Shooting] is set to [ON]) Select [End].
•
After the recording stops, a confirmation screen will be displayed, asking whether to
proceed to create a motion picture.
To create a motion picture, select [Yes].
For information on creating motion pictures, refer to P209.
[Auto
Shooting]
[ON]
Takes pictures automatically at a set recording interval. When the
shutter button is pressed fully, recording starts.
[OFF] This is for taking pictures manually, frame by frame.
[Shooting
Interval]
(Only when [Auto Shooting] is set to [ON])
Sets the interval for automatic recording. A value between 1 and 60 seconds
can be set in 1 second intervals.
Press 2/1 to select the recording interval (seconds), press 3/4
to set it, and press [MENU/SET].
•
Automatic recording may not take place at set intervals because recording
takes time under certain recording conditions, such as when the flash is
used for recording.
Recording materials skilfully
•
The recording screen displays up to two pictures taken previously. Use them as
reference for the amount of movement.
• Pressing [(] allows you to check recorded pictures.
Unnecessary pictures can be deleted by pressing [ ].
Pressing [(] again will return you to the recording screen.
AFS
L
4:3
30
To Next Page
Loading...
Need help?
General
