8. Stabiliser, Zoom and Flash
232
∫ The available flash range (approximation)
When you use certain lenses, light from the flash may be
blocked or fail to cover the lens field of view, causing dark
areas to appear in the resulting pictures.
The distance at which light from the flash is blocked by lens, and
the distance to which light from the flash is delivered vary
depending on the lens used. Check the distance to the subject
when taking a picture.
•
These ranges are obtained, the ISO sensitivity is set to [AUTO], and [ISO Limit Set] (P177) is
set to [OFF].
• Do not bring the flash too close to objects or close the flash while it is activated. The objects
may be discoloured by its heat or lighting.
• Do not close the flash soon after the flash is activated prior to taking pictures due to Forced ON/
Red-Eye Reduction etc. It causes a malfunction.
• It may take time to charge the flash if you repeatedly take pictures. You must wait a moment to
take the next picture while the flash icon is blinking red indicating the flash is charging. Take a
picture after the access indication disappears.
• When you attach an external flash, it takes priority over the built-in flash. Refer to P360 for the
external flash.
When the interchangeable lens (H-FS1442A) is used
Wide Tele
0.5 m (1.6 feet) to 7.5 m (25 feet) 0.3 m (0.98 feet) to 4.7 m (15 feet)
When the interchangeable lens (H-FS45150) is used
Wide Tele
0.9 m (3.0 feet) to 6.6 m (22 feet) 0.9 m (3.0 feet) to 4.7 m (15 feet)
When the interchangeable lens (H-FS14140) is used
Wide Tele
0.8 m (2.6 feet) to 7.5 m (25 feet) 0.5 m (1.6 feet) to 4.7 m (15 feet)
To Next Page
Loading...
Need help?
General
