8. Stabiliser, Zoom and Flash
240
¢1 Not available when [Wireless FP] is set to [ON].
¢2
You can select these options only when the external flash is attached to the camera.
[Built-in
Flash]
¢1
/
[External
Flash]
¢1
[Firing Mode]
[TTL]: The camera automatically sets the output.
[AUTO]:
¢2
Flash output is set by the external flash.
[MANUAL]:
¢2
Set the luminosity ratio of the external flash manually.
[OFF]: The flash on the camera side emits only communication light.
[Flash Adjust.]
Set the flash output of the camera manually when [Firing Mode] is set to
[TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the external flash when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
• When an external flash is not attached to the camera, these settings will be
set for the built-in flash; when an external flash is attached to the camera,
they will be set for the external flash.
[A Group]/
[B Group]/
[C Group]
[Firing Mode]
[TTL]: The camera automatically sets the output.
[AUTO]:
¢1
The wireless flashes automatically set the output.
[MANUAL]: Set the luminosity ratio of the wireless flashes manually.
[OFF]: The wireless flashes of the specified group will not fire.
[Flash Adjust.]
Adjust the output of the wireless flashes manually when [Firing Mode] is set to
[TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the wireless flashes when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
To Next Page
Loading...
Need help?
General
