11. Using the Wi-Fi function
296
∫ Using a password to set up a connection
When [Wi-Fi Password] is set to [ON], you scan a QR code or manually enter a password to
set up a connection. Taking either of these steps will improve your security.
• To scan a QR code with “Image App” on an iOS device, iOS 7.0 or later is required.
1 Select the menu on the camera. (P63)
•
The information required for connecting the smartphone to this unit (QR code, SSID and
password) is displayed.
• You can also display the information by pressing [Wi-Fi] on the camera.
2 Operate the smartphone.
•
The connection method differs according to your smartphone.
If you are using an Android device
1 Start “Image App”. (P294)
•
If a message appears stating that a camera search is in progress, close the message.
• When the smartphone is connected to a wireless access point, it may take time to
display the message.
2 Select [Wi-Fi].
3 Select the SSID displayed on the screen of the camera.
•
The connection confirmation screen is displayed on the camera. Select [Yes]. (Only
when connecting for the first time)
Preparations
(On the camera)
•
Set [Wi-Fi Password] to [ON]. (P337)
(On your smartphone)
•
Install the “Image App” in advance. (P294)
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Remote Shooting & View]
If you are using an iOS device
When scanning the QR code to set up a connection
(If you are reconnecting the camera, steps 1 to 5 are not required)
1 Start “Image App”. (P294)
2 Select [QR code], and then select [OK].
•
When the smartphone is connected to a wireless access point, it may take time to
display [QR code].
MENU
To Next Page
Loading...
Need help?
General
