11. Using the Wi-Fi function
322
1 Select the menu. (P63)
2 Select [Via Network], and connect. (P328)
3 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P336)
4 Take pictures.
•
To terminate the connection, follow the steps below:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes]
• You can terminate the connection or change the send settings by pressing [Wi-Fi]. (P292)
You cannot change the settings while sending pictures. Wait until sending is complete.
1 Select the menu. (P63)
2 Select [Via Network], and connect. (P328)
3 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P336)
4 Select [Single Select] or [Multi Select].
Sending an image each time a recording is made ([Send Images While
Recording])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images While Recording] > [Cloud Sync. Service]
Select and send the images ([Send Images Stored in the Camera])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images Stored in the Camera] > [Cloud Sync. Service]
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is cancelled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi
Select] is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
• To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
MENU
MENU
To Next Page
Loading...
Need help?
General
