Others
Troubleshooting
lil'1
mI!f<\;~~l:!lIIIl!i!ll1Iml:lilelJlll!l
~~~~~~BIli'S1!!IiIIiI'
i1ilIIIl
I.UlWi!l!.lI'~'I!!IIM_~~Im
••
· l!i1.aIll>WiII.!.
__
IIIIIIl!l!lI
__
I.m'li'l!~~
If
you
put the menu back to the settings at the time of purchase, the conditions may
be
improved. Carry out the [RESET]
in
the setup menu while the camera is
in
the recording
mode. (P23)
• Batteries and
power
supply
Conditions
Causes
..
The camera
turns
off
The remaining battery power may not be displayed
immediately even
when
accurately, and the camera may suddenly stop working, when
battery
power
is
full.
the type of battery and the settings
on
[BA
TIERY
TYPE] are
The remaining
battery
not identical. However this is not a malfunction. Depending
power
is
low
even
if
new
on the battery brand and the operating temperature, or if
batteries are inserted.
exhausted batteries are used, the remaining battery power
may not be displayed accurately.
Please check [BATTERY TYPE] (P21)
in
the [SETUP] menu.
The camera
will
not
turn
Are the batteries inserted correctly?
on.
Use sufficiently charged batteries when using Ni-MH
batteries.
The
picture
is
not
Is the economy mode (P22) activated? Press the shutter
displayed on
the
LCD button halfway to deactivate these modes.
monitor.
Are the batteries exhausted? Replace them with batteries
which have sufficient capacity. (When you use Ni-MH
batteries, charge them.)
The camera
turns
off
• Are the batteries exhausted? Replace them with batteries
soon
after
turning
it
on.
with sufficient charge. (When you use Ni-MH batteries,
charge them.)
• If you leave the camera
on,
the battery will be exhausted.
Turn the camera off frequently by using economy mode
(P22) etc.
•
Shooting
Conditions
Causes
The
picture
cannot
be
Is
the mode correctly set?
recorded.
Is
there any memory capacity left
on
the built-in memory or
the card?
Before recording, delete some pictures. (P38)
The recorded
pictures
The picture can become whitish if there
is
dirt e.g. fingerprints
are pale.
on the lens. If the lens
is
dirty, turn on the camera, eject the
lens barrel and gently wipe the lens surface with a soft dry
cloth.
The recorded
picture
is
Check that the exposure
is
correctly compensated. (P48)
too
bright
or
dark.
2
or
3
pictures
are
taken
Is
auto bracket (P49), [HI-SPEED BURST] (P60) or burst
at one time.
(P75) mode set?
114
To Next Page
Loading...
