Preparation
For
USA
assistance.
please call:
1·800-211-PANA (7262) or. contact us via the web at:
http://www.panasonic.com/contactinfo
For Canadian assistance. please call.
1-800-99-LUMIX (1-800-995-8649) or send e-mail
10
~
~
m/ft
~
SCENE MENU (P52, 55)
MENU •
Press
[~]
to
display
menu,
enter
the
setup
menu
[~]
and
select
the
item. (P20)
The
setting
marked
"~"
means
it
is
the
initial
setting.
memory than
the
card.
(Max.
about
15
sec.)
• You cannot format an
SO
Memory Card
or an SDHC Memory Card when the
card's Write-Protect switch set to [LOCK].
• If the card has been formatted on a
PC
or
other equipment, format it on the camera
again.
• If the built-in memory or the card cannot
be formatted, consult your nearest
Service Center.
Set the unit to display available recording
range
Setup the screen in advanced scene mode
or scene mode
~
DIAL DISPLAY
Set whether the mode dial position is
displayed on screen when turning the
mode dial.
Initializing the built-in memory
or
1!1
a card.
FORMAT
Usually, it is not necessary to format the
built-in memory and the card. Format them
when the message [BUILT-IN MEMORY
ERROR] or [MEMORY CARD ERROR]
appears. Use batteries with sufficient
power when formatting.
[1::J
•
Once
formatting
has
been completed,
all data
including
protected
pictures
will
be
deleted. Make
sure
not
to
delete
them
before
formatting
• When the card is not inserted, built-in
memory can be formatted. When the card
is inserted, the card can be formatted.
• Do not turn the camera off during
formatting.
•
It
may take longer
to
format the built-in
24
•
LANGUAGE
Set to the language
on
the menu screen
from the following languages.
;<~~"'#'
'1.;;';1;~~'.;';;J;~~'
'<,:,'j
; -
:':'--'~:-
~';(f
'<~:~~~-'<,-.
~.
','"
"
....
-~.:~,.'.,,/-;;;:.
;-,:';;
.
..,
:.':-.:".
' .
'.
;.~.,
~
/,'-
'~,~,"~/";<
ii<?I~f~~~~J~(ff~j);ij~,i~~·'.
>.>
..
';,'
",}?:.,~
".
:It:rA~t~f:101:,'
..f!alli\n.
'.
. .
5;~,;;
[ll.'41~k
.'
'Cbines~(Traditional)*···
tEJ,~.]:
',J,apanese"
.'
* Available
in
Canada only
• When you set to another language by
mistake, select
[r)m]
from the menu icons
to set the desired language.
VQT1L86
To Next Page
Loading...
