EasyManua.ls Logo

Panasonic LUMIX DMC-LZ8

Panasonic LUMIX DMC-LZ8
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Others
Conditions Causes
The LCD
monitor
turns
Have you set [AUTO LCD OFF]? (P22)
off
during
use.
The LCD monitor
The camera
is
charging for flash recording.
It
may darken the
sometimes becomes
LCD display for efficient charging.
dark
during
use. The monitor may darken
in
the following cases.
After flash recording
Just after turning the camera
ON
Just after setting to recording mode
When adjusting the zoom or pointing the camera toward
dark side
The LCD monitor lights up again to return to recording-ready
condition.
The brightness
of
the This phenomenon appears when pressing the shutter button
LCD
monitor
becomes halfway to set the aperture value and does not affect the
dark
or
bright
for
a recorded pictures.
moment.
The LCD
monitor
The LCD monitor may flicker for a few seconds after turning
flickers indoors. the camera
on
indoors under fluorescent light.
This is not a malfunction.
The LCD
monitor
is
too
Adjust the brightness of the LCD monitor. (P21)
bright
or
dark.
Is
the power LCD or the high angle mode activated? (P42)
Black, red, blue and This
is
not a malfunction.
green
dots
appear on
These pixels do not affect the recorded pictures.
the LCD monitor.
Noise appears
on
the
In
dark places, noise may appear to maintain the brightness
LCD monitor. of the LCD monitor. This does not affect the pictures you are
recording.
Flash
~,:
" '
CQta~lti()ns'
"_',~.:,
';
';::,.
,~<,~,;
':
,\,,(:,"
,'Causes
""
\.,\/' . "
,,},'c:
.~"
_ "
,,"
',',"F,'
__
"
,,'
_ ,
Flash
is
not
activated.
Is
the flash setting set to Forced OFF [@]?
Change the flash setting. (P43)
The flash
is
not activated when motion picture mode [lEI],
[SCENERY], [NATURE], [ARCHITECTURE], [CREATIVE
SCENERY], [NIGHT SCENERY], [ILLUMINATIONS],
[CREATIVE NIGHT SCENERY], [SUNSET], [HI-SPEED
BURST], (STARRY SKY], [FIREWORKS], [AERIAL PHOTO]
mode, burst or auto bracket mode
is
selected.
The flash is activated 2 When you select red-eye reduction (P43), the flash is
times.
activated once before the actual recording to reduce the red-
eye phenomenon (eyes of the subject appearing
red
in
the
picture) and then activated again for the actual recording.
116

Related product manuals