Preparation
Inserting/Removing the Batteries/Card (Optional)
I
3 GClose the battery door
or
the
card door.
8Slide
the battery
door
or
the
card
door
to
the end and then
close
it
firmly.
• The card may be damaged if it is not fully
inserted.
•
If
the card door cannot be completely
closed, remove the card, check its
direction and insert it again.
~
..
~
• Select the battery type being used
in
[SA
TTERY TYPE] in the [SETUP]
menu. (P21)
• Remove the batteries after use.
• Remove the batteries after the LCD
monitor
and the status indicator
(green)
turn
off. Otherwise, the
settings on the camera may
not
be
stored properly.
• Do
not
remove
or
insert the batteries
or
the card while the
unit
is
on,
particularly while accessing the
built-in memory
or
the card. This can
damage data.
•
We
recommend
using
Panasonic's
SO
Memory Card/SOHC Memory Card.
~i;8
Press and keep the lever down
and slide the door.
2 Batteries:
Insert the batteries with the (f) and 8
poles aligned correctly.
Card:
Insert the card with the label side
facing the back
of
the camera until it
clicks
and locks.
To remove
the
card, push the card
until
it
clicks, then pull the card
out
upright.
• Check that the camera is turned off.
• Use alkaline batteries (supplied), Ni-MH
batteries (optional) or oxyride batteries
(optional).
• Prepare a card.
• You can record
or
play back pictures
on
the built-in memory when you are
not
using a card. (P16)
1 Slide the battery
door
®
or
the
card
door
®
to
open it.
• Do not touch the connection terminals on
the back side of the card.
15
VQT1L86
To Next Page
Loading...
Need help?
General
