VQT2R48 97
For [REC] menu setting procedures (20)
Slow-moving subject
Fast-moving subject
ISO Sensitivity 200
(Shutter speed 1/30)
ISO Sensitivity 800
(Shutter speed 1/125)
Shutter speed and ISO Sensitivity are displayed in the screen for a few seconds after
recording.
If interference becomes noticeable, we recommend reducing the setting, or setting
[NOISE REDUCTION] in [PICT.ADJ.] in the + direction.
Blurring may occur depending on brightness, size, position, and speed of movement of
the subject (e.g. if subject is too small, is on edge of picture, or starts moving as soon
as shutter button is pressed).
Scope of flash recording (48)
[SENSITIVITY]
Set ISO Sensitivity (sensitivity to lighting) manually.
We recommend higher settings to take clear pictures in darker locations.
Recording Mode:
Settings: [AUTO] / [80] / [100] / [200] / [400] / [800] / [1600]
Setting guide
[SENSITIVITY] [80] [1600]
Location
(recommended)
Bright
(outdoors)
Dark
Shutter speed Slow Fast
Interference Low High
[AUTO] is automatically set in a range up to 400 (1000 when flash is used) based on
subject movement and brightness.
Scope of flash recording (48)
Cannot be set when [INTELLIGENT ISO] is used ( is displayed)
If interference becomes noticeable, we recommend reducing the setting, or setting
[NOISE REDUCTION] in [PICT.ADJ.] in the + direction.
To Next Page
Loading...
