VQT2R48 103
For [REC] menu setting procedures (20)
[BURST]
Enables a rapid succession of still pictures to be taken. Succession of still pictures taken
while shutter button is held down.
Recording Mode:
Settings:
[BURST] setting
Speed No. of pictures
[OFF]
No burst
(Burst)
2.3 pictures/sec.
Fine: Max. 3
Standard: Max. 5
When using self-timer: Fixed at 3 pictures
Focus, exposure and White Balance are fixed in the first picture.
Burst speed may be reduced if [SENSITIVITY] is set to high, or if shutter speed is
reduced in darker locations.
When burst setting is used, flash is set to [FORCED FLASH OFF], and [AUTO
BRACKET], [MULTI ASPECT], and [AUDIO REC.] settings are cancelled.
When burst is performed with the built-in memory, writing will take some time.
Settings will be stored even if power is turned off.
Auto Review performed regardless of [AUTO REVIEW] setting.
Burst is not available in the Scene Modes [TRANSFORM], [PANORAMA ASSIST], [HI-
SPEED BURST], [FLASH BURST], [STARRY SKY], [PIN HOLE], [FILM GRAIN], [HIGH
DYNAMIC],and [PHOTO FRAME].
Using the [HI-SPEED BURST] Scene Mode allows a faster succession of still pictures
to be taken. [FLASH BURST] is convenient to take continuous still pictures using flash
in dark places.
[I.RESOLUTION]
Super resolution technology can be used to record still pictures with sharper outlines and
clearer resolution. Also, when [i.ZOOM] is set, the zoom ratio can be increased to about
1.3 with almost no deterioration of picture quality.
Recording Mode:
Settings: [OFF]/[ON]/[i.ZOOM]
About i.ZOOM (41)
The setting is fixed to [i.ZOOM] in ([INTELLIGENT AUTO] Mode) and
([CLIPBOARD] Mode).
The setting is fixed to [ON] in [HIGH SENS.] and [HI-SPEED BURST] Scene Modes,
[OFF] in [FLASH BURST] and [PIN HOLE] Scene Modes, and [i.ZOOM] in other Scene
Modes.
To Next Page
Loading...
