14 Bar code object
3. In the dialog, do any of the following:
• For “Module width [mm]”, you can input a new value.
• Select “Details” to display the list of parameters that will automatically be optimized.
To return to the “Optimal setting” dialog, select “OK”.
4. If you want to optimize the parameters, confirm the “Optimal setting” dialog with “OK”.
The optimal values for the parameters are determined. A dialog appears that shows a
list of parameters that will be optimized.
5. To close the dialog, select “OK”.
Related topics
Set parameters for GS1 DataBar (page 152)
154 ME-NAVIS2-OP-1
To Next Page
Loading...
