Panasonic NAVI smart - Page 18

Table of contents
24.10 Specify the laser power correction........................................................................................... 262
24.11 Adjust the marking field position...............................................................................................262
24.12 Set the laser head direction..................................................................................................... 264
24.13 Specify input and output settings............................................................................................. 265
24.14 Specify Ethernet communication settings.................................................................................266
24.15 Specify RS232C communication settings.................................................................................267
24.16 Enable Bluetooth.......................................................................................................................268
24.17 Specify EtherNet/IP communication settings............................................................................269
24.18 Specify PROFINET communication settings............................................................................ 270
24.19 Specify the command format....................................................................................................272
24.20 Make imagechecker communication settings...........................................................................273
24.21 Specify settings for code reader functions............................................................................... 274
24.22 Optimize the laser power of specific marking field areas.........................................................275
24.23 Marking field calibration............................................................................................................ 277
24.23.1 Calibrate the marking field.................................................................................................277
24.23.2 Details of distortion correction settings..............................................................................279
24.24 Set or disable a password........................................................................................................280
24.25 Delete a forgotten password.................................................................................................... 281
24.26 Configure permissions and customize the “Monitor” screen.................................................... 282
24.27 Specify more permissions and “Monitor” screen settings.........................................................282
25 Monitor the marking data.................................................................................................... 285
25.1 Monitor the marking data in remote mode or RUN mode.......................................................... 285
25.2 Select a marking file on the “Monitor” screen............................................................................ 286
26 Maintenance.......................................................................................................................... 288
26.1 Display operating data................................................................................................................288
26.2 Show the error log......................................................................................................................289
26.3 Perform output simulation...........................................................................................................289
26.4 Check the communication command history..............................................................................290
26.5 Inspect the laser power.............................................................................................................. 291
27 Troubleshooting.................................................................................................................... 294
27.1 List of common problems........................................................................................................... 294
27.2 Start-up........................................................................................................................................295
27.3 Laser pumping............................................................................................................................ 296
27.4 Connection with Laser Marker NAVI smart................................................................................ 297
27.5 Lasing process............................................................................................................................300
18 ME-NAVIS2-OP-1