Editing
Assembly Editing
This function can be used to make up an edited tape from
other recordings or video sources.
This enables you to record a new segment immediately
after a previously recorded segment.
1
2
AUDIO IN
VIDEO IN
3
00 REC
REC
4
Operations
Preparation
*Connect a movie camera or another VTR to this VTR as
shown.
•
Insert a recorded cassette tape with an intact erasure
prevention tab.
•
Select the video source required by pressing
INPUT
SELECT
to set A1.
1
Search for the end of the previous
recording.
2
Press
PAUSE/STILL
at the end point.
PAUSE/
STILL
11
3
Set for the new recording by pressing
REC.
•
REC
4
Start the new recording by pressing
PAUSE/STILL
again.
PAUSE/
STILL
11
Note:
The new sound will be recorded on both the normal and
Hi-Fi sound tracks, only monaural sound recording is
possible on the normal sound tracks.
22
To Next Page
Loading...
