Panasonic Omnivision PV-V4640

— Use Guide |
(
Make ali connections (page 4).
Connect VCR and TV with AV Cable (not supplied) or RF Coaxial Cable (supplied) as shown below.
To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO.”
Use the L Audio OUT jack for proper sound reproduction when connecting to a monaural TV.
ANTENNA (See pages 4, 5)
IN FROM ANT. a) AV CABLE
{not supplied) RO AUDIO
LO
OUT TO TV | | | | O VIDEO
OO VHF
Cap 1) While connection b) (above) is sufficient, connection a) offers better sound and picture
(especially with this model, you can enjoy Hi-Fi STEREO sound).
2) For both connections a) and bì proceed as follows:
¢ To use VCR : VCR Power on, set TV to VIDEO.
* To watch TV : VCR Power off, select channel on.
3) When using connection b) (see page 4), tune to VCR's output channel.
4) Set VCR Output to channel 3 or 4 (not an active station). (See page 8.)
Record on a Tape
Playback a Tape
2 Do “One Time VCR Setup” on page 6.
In order for the VCR to properly interface with your
equipment, some setup is necessary.
2 Play your Tape.
=== Insert a tape
: í CO
aa
catan
|
3
Record
on
a
Tape.
Insert a tape
with Record Tab
Press PLAY
(Starts playback)
* Or, if tape has no record
Al
tab, auto playback begins.
Press CH Up/Down.
(Select Channel)
0)
O I
4TRACKINGD
SPEED Press SPEED.
{Change speed)
Press REC.
(Starts Recording)
Panasonic Consumer Electronics Panasonic Sales Company, Printed in Japan -à
Company,
Division
of
Matsushita
Division
of
Matsushita
Electric
of
LSQTO194A
Electric
Corporation
of
America
Puerto
Rico,
Inc.
(“PSC”)
$0100-0
One
Panasonic
Way
Secaucus,
Ave.
65 de
Infanteria.
Km.
9.5
New
Jersey
07094
San
Gabriel
Industrial
Park,
Carolina,
Puerto
Rico
00985
[P|