/U_'t4"q.'-_lf_/_"_,t_dtt_r_'_RtW_rVl7_" Before you begin...
Your can enjoy both indoor and outdoor • Connect the Palmcorder to a power source.
recording using the ready-to-use light. •Set the POWER switch to CAMERA,
Press LIGHT button ON.
Pressagain to turn off.
Caution:
This light becomes hot during
operation. Make sure nothing
covers the Light during operation.
Turn screw counter-
clockwise and
Before you begin...
• Set the POWER switchto OFF.
Remove the Built-in Light unit
from the Palmcorder.
Turn the Bulb Housing counterclockwise 1/4 of a
turn and pull free from the Built-in Light unit.
Built-in Bulb Housing
Light Unit
Danger:
When replacing the bulb, use only lamp bulbs
(PART NO. VLLWO007) supplied by
Panasonic to reduce the risk of fire.
Use a cloth or tissue when handling the bulb
as finger oils will decrease the bulb life.
To prevent possible burn hazard, disconnect
the Built-in Light and allow the lamp to cool
before replacing. ._
ng a clean cloth or _, _L-_(-.-_ J
tissue, replace the bulb.
Replace the Bulb Housing turning it
clockwise, then replace the Built-in
Light Unit. Finally, replace the screw.
Note:
• If usingthe Built-in Lightfor an extended
periodof time, be sureto provideventilation
when ina hot environment.
• UsingtheBuilt-inLightwhenthe Palmcorderis
powered bya car bafferymay shortenbulb life.
17
To Next Page
Loading...
