Your Palmcorder may be connected to a
TV to play back tapes or to view what you
are recording.
CTV with AUDIO/VIDEO IN Jacks.
Audio In
I,
;To Audio
Audio/Video
Cable
(Supplied)
To Audio/Video Out
Before you begin...
• Connect thePalmcorderto a powersource.
Set the POWER switch to VCR to
playbacka tape.
Or, set to CAMERA to viewwhat your
Palmcorderis recording.
Turn the TV ON and set It to LINE
Video In_ INPUT
,1 ._,'_ )_ Check your TV operating instructions
_(_._j___.J_, )) for further information.
To Video In I_-__ Note:
I I ] Ifyour TV has no VIDEO orAUDIO IN
I 1% Jacks, select CH 3 or 4 on your TV to match
_/ _ the RF AdaptorCH 3/4 switchand set the
VCR/TV selectoronthe RF Adaptorto VCR.
Start playback or begin a recording.
TV without AUDIO/VIDEO IN Jacks.
( (_0 Audio/Video Out_
I RF Adaptor
I(oP tional) T VHFAntenna
I t_l_"l 300 ohm-75 ohm
| CH 3/4 Switch J]_H transformer
k _ _ (not supplied)
"_q_'_ or F Connector
/ - _ UHFAntenna
vc v -
VHF Connecting _
cab,e II
(not supplied) I"__ _
To VHF Antenna J_vO_.____
24 Terminal
This feature allows you to remove all
Electronic Viewfinder Indications.
Before inserting a tape, press DISPLAY
and STOP together for more than one
second to remove the indications except
time and date*.
To display the Electronic Viewfinder
Indications again, turn the Palmcorder
Power off and then again on.
* To remove the time and date, refer to
page 15.
Ifyou have connected the Palmcorderto
yourTV usingan RF Adaptor:
Set the POWER switch to OFF on the
Palmcorder.
Then, set the VCR/TV Selector on the
RF Adaptor to TV.
Now, turn the "I'V ON and select a
channel.
f
To Next Page
Loading...
