Remove the Lens Hood by turning it counterclockwise.
Then attach an optical filter or lens.
• Be careful not to touch the lens itself.
• Replace the Lens Hood after removing the accessory.
PV-IQ225/PV-IQ425 PV-IQ325/PV-IQ525
To Remove To Remove
Turn the EVF Eyepiece
counterclockwise 1/8 of a
_x"¥J'_41"== 2Pull free.
Pull free.
Remove any lint or dust particles with a
soft clean cloth being careful not to scratch
the glass surfaces.
To re-install EVF
Line up the marks on the Eyepiece with
the grooves inside the EVF shaft and
attach. Turn the EVF clockwise 1/8 of a
turn to lock in place.
Slide and hold the EYEPIECE
RELEASE button. _
Remove the eyepiece. (Do not twist.)
Remove any lint or dust particles with a
blower, available at photography stores.
Do not touch lenses with fingers.
Now, replace the eyepiece.
void the user's authority to operate, i
.J
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: ('1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with Part 15 and part 18 of the FCC
Rules. These limitsare designed to provide reasonable protection against harmful interference
when operated in a residentiatenvironment.
|t this equ'_pment does cause interference to radio or te|evision reception,whichcanbe _etermined
by turning the equipment off and on, use the equipment in another location and/or utilize an electri-
cal outlet different from that used by the receiver.
If necessary, consult the dealer or an experienced radio/TV technician for help.You may find the
booklet, 'Something About Interference' available from FCC local regional offices helpful.
34
To Next Page
Loading...
