Before you begin...
• Connect the Palmcorder to a power source.
•Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER switch to VCR.
Press PLAY on the (playing)
Palmcorder. When the tape reaches
the point you want to start dubbing,
press STILL.
Insert a pre-t'edorded tape
into the source (playing)
Palmcorder and a blank tape with
record tab into the recording unit.
Press PLAY and REC together
then immediately press STILL on
the recording unit.
nl==U
VCR Buttons
(Playing)
Palmcorder
_VHF Connecting Cable
(not supplied)
I/
To Audio In
Press STILL on the playing
Palmcorder and PAUSE/STILL
on the recording unit to begin
copying your tape.
Press STOP on both units
when dubbing is complete.
--Audio In -,_
_o_o I Rec°rding: 1_1
VCR J '_
Video In
114)=-0)i(t(0)= (_1nil,,z0) __Jllv==
• Turn the TV ON and select its VCR
channel (,either CH3 or CH4).
• Set the VCP, i'TV Selector on the
recording VCR to VCR.
IcUCAUTION: _,
nauthorized exchangingand/or copyingof|
opyrlghted recordings may be copyright
ntringement. )
31
To Next Page
Loading...
